Intended Use; Mounting The Tool; Mounting The Cutting Attachment - Stihl AWG Manual De Instrucciones

English

Intended use

The STIHL balancer accurately
measures radial and axial out-of-
balance on cutting attachments with two
or more teeth.
WARNING
Out-of-balance causes vibrations on
high speed cutting attachments which
are transmitted to the power tool and
increase the risk of accidents.
Do not exceed the maximum limit for
imbalance specified by STIHL.
Out-of-balance can occur when the
teeth of cutting attachments are
resharpened unevenly.
Test the cutting attachment during
N
or after resharpening.
12

Mounting the Tool

Mount the balancer on a vertical
N
surface, leaving sufficient clearance
for larger cutting attachments.
Protect the balance from dust and
N
dirt.
Mounting the Cutting
Attachment
Fitting the Cutting Attachment
Push the annular magnet (1) back
N
against the mounting.
1
AWG