Testing Cutting Attachment - Stihl AWG Manual De Instrucciones

Position the cutting attachment (2)
N
on the cone (3).
Pull the annular magnet forward
N
against the cutting attachment – the
magnet holds the cutting
attachment in position.
AWG
Removing the Cutting Attachment
2
3
Release the cutting attachment
N
from the annular magnet with a
sharp pull.

Testing Cutting Attachment

If the balancer has not been used
N
for a prolonged period or if the test
is carried out at low temperatures,
rotate the cutting attachment
several times to ensure the spindle
bearing runs freely.
Test the cutting attachment during
N
or after resharpening.
Testing axial out-of-balance
Fit the cutting attachment.
N
English
13