Troubleshooting - Heiniger Opal Traducción Del Manual Original

7

Troubleshooting

y The here described tasks for troubleshooting can be done mostly by the
operator.
y Some tasks only may be done by especially trained personal or by an
authorised service centre. These tasks are marked with (S).
Malfunction
Top blade does not
move
Clipper cuts badly
or not at all
No speed difference
between level I and
level II
Motor is not running Battery is dead
Running time of a
fully charged battery
is too short and / or
blades are getting
hot
No data displayed
on the charging sta-
tus display
18
Cause
Clipperhead is not well
engaged
Turning lever is defective Replace turning lever (S)
The top and bottom
blades stick to each
other
Clipper blade is blunt
Clipper blades have not
been correctly ground
Clipper blades are not
oiled
The animal's hair is wet
Hairs jammed between
top and bottom blades
Clipperhead has too little
clipping pressure
Faulty motor and / or
electronics
Contacts dirty
Faulty battery
Smell of burning from
the motor housing. Motor
burned out.
Faulty motor and / or
electronics
Clipperhead blocked
Clipper blades were not
oiled sufficiently
Dead, not fully charged
or defective battery has
been used
Battery exhausted
Faulty battery
Translation of the original instructions / Small animal clipper
Rectification
Engage the clipperhead correctly
when the motor is running
Clean and oil the blades
Have top and bottom blades res-
harpenend by service centre (S)
Oil clipper blades every 15
minutes
Only clip dry hair
Take off clipperhead, push the
top blade half away from the
clipperhead, take away hairs
between top and bottom blade.
Have clipperhead inspected (S)
Notify customer service
Charge battery
Switch clipper off and clean the
contacts
Replace battery
Have motor and / or electronics
replaced (S)
Have motor and / or electronics
replaced (S)
Clean and oil clipperhead
Oil clipper blades
Only use intact and completely
charged original battery
Place the battery in the charging
station
Replace battery