JVC XL-PM25SL Instrucciones De Funcionamiento página 12

9
ON HOLD OFF
HOLD
Preventing Accidental
Operation
(HOLD mode)
The HOLD switch on the unit/remote control is prepared
to prevent an accidental operation by an unexpected but-
ton press.
Hold mode prevents the following:
• Powering on the unit accidentally (which can cause the
batteries to go dead).
• Play being cut off unexpectedly.
• Unexpected operation during play. (Set the HOLD
switch to the ON position after you start playing disc.)
To set the unit/remote control in HOLD mode
• Set the HOLD switch on the unit/remote control to the
ON position. The all buttons on the unit/remote control
are disabled.
"HOLD " indication
When the unit is in HOLD mode, "HOLD" will be displayed
if a button on the unit is pressed.
To release the HOLD mode
Set the HOLD switch to OFF position.
Notes:
• Before turning on the unit, be sure that HOLD is OFF.
Otherwise, you cannot turn on the unit.
• The HOLD switch on the unit is effective for the unit
only. While, that on the remote control is effective for
the remote control only.