Technical Data; Standard Accessories; Optional Accessories; General Conditions Of Use - Corghi EM9980 Manual De Uso

TECHNICAL DATA

Power supply voltage: ................................ 1Ph 115V 50-60Hz
................................................................... 1Ph 230V 50-60Hz
Overall power: ..................................................................550 W
Balancing speed:................................................. 70-85-98 rpm
Maximum unbalance value calculated: ........................... 999g
Average spin time (with 5.5"x14" wheel): ...................... 7 sec
Unbalance reading resolution:... ...................................1 - 5 g
Angle position resolution:... ............................................ 0.7 °
Shaft diameter: .............................................................. 40 mm
Working environment temperature: ........................ 0 to 50°C
Machine dimensions
EM9980 - Operator's manual
- height with guard closed: ...................................... 1652 mm
- height with guard open: ................................... ....1860 mm
- Width: ....................................................................... 1616 mm
- Depth with guard closed: ...................................... 1378 mm
- depth with guard open: ........................................... 894 mm
Measurable rim width: .................................... from 1 " to 23 "
Measurable rim diameter: ............................ from 10 " to 32 "
Max wheel/machine distance: .................................... 360 mm
Max wheel width (with guard): ................................... 560 mm
Max wheel diameter (with guard): ........................... 1118 mm
Max wheel weight: ............................................................ 75 kg
Machine weight (without accessories): ........................ 183 kg
Operating noise level: ..............................................<70 dB(A)

STANDARD ACCESSORIES

The following parts are supplied together with the
machine.
Weight pliers
Calliper for wheel width measurement
Sliding flange holder kit
Calibration weight
Wheel balancer power supply cable
Monitor power supply cable
Kit 4 cones
Wheel fixing cap protection
Wheel spacer
Wheel fixing cap
C VERSION
C hub
C locking device
C hub key

OPTIONAL ACCESSORIES

Please refer to relevant accessories catalogue.
GENERAL CONDITIONS OF
The equipment is intended for professional
use only.
Only one operator at a time can work with the
11
machine.
The wheel balancers described in this manual must
Working range
USE
WARNING
UK
49