Corghi EM9980 Manual De Uso página 63

3.
W H E E L D I A G N O S I S
4.
UNBALANCE OPTIMISATION PROGRAMME
5.
AUTOMATIC CLAMPING SYSTEM HUB
REMOVAL/ASSEMBLY MODE
6.
CONFIGURATION PROGRAMMES
1. SPIN COUNTER
Three counters are displayed on the screen:
-
the number of partial spins made since the
last manual reset;
-
the total number of spins performed by the
machine since its first start-up;
-
the number of wheel spins performed since
the last sensitivity calibration.
If the Weight Management suite is enabled, the
spin counter icon in the Utility programmes menu
becomes and displays:
-
the total number of spins performed by the
EM9980 - Operator's manual
-
P R O G R A M M E
-
-
-
The Reset button
reset the partial spin counters and the weight
quantity saved.
To quit the counter display, press the Exit but-
ton
If connected to an approved printer, the Print
menu secondary control key
used to start the print procedure for the Less
Weight programme.
2. MANUAL ENTRY OF WHEEL DIMENSIONS
In the event of failure of the internal and/or
external laser sensors or incorrect measurement
of one of the three working dimensions, the
geometric data can be entered manually using
the following procedure.
A screen is displayed with the default or previ-
ously measured wheel dimensions.
machine since its first start-up;
the number of partial spins made since the
last manual reset;
the total weight quantity saved by the machine
since its first start-up;
the partial weight quantity saved since the
last manual reset;
two histograms that compare the quantity
of weight required if the "Less Weight" pro-
gramme (red bar) is not used and
the quantity required if the "Less Weight"
programme (green bar) is used for
the entire service life of the machine for clip
and adhesive weights.
.
can be used to
UK
can be
63