Husqvarna R112C Manual De Usuario página 26

Problem
The starter motor does not turn
the engine over
The engine does not start when
the start motor turns the engine
over
The engine does not run smooth-
ly
The engine apparently has no
power
The battery does not charge
There is vibration in the product
26
Cause
The parking brake is not applied. See
page 16 .
The lift lever for the cutting deck is in mow position. See
ting deck on page 13 .
The main fuse is blown. See
The ignition lock is defective.
The connection between the cable and the battery is bad. See
battery on page 22 .
The battery is too weak. See
The starter motor is defective.
There is no fuel in the fuel tank. See
The spark plug is defective.
The ignition cable is defective.
There is dirt in the carburettor or fuel line.
The spark plug is defective.
The carburettor is incorrectly set.
The air filter is clogged. See
The fuel tank vent is blocked.
There is dirt in the carburetor or fuel line.
The throttle control is set to choke position or the throttle wire is incorrectly ad-
justed
The air filter is clogged. See
The spark plug is defective.
There is dirt in the carburetor or fuel line.
The throttle control is set to choke position or the throttle wire is incorrectly ad-
justed
The battery is defective. See
The connection at the cable connectors on the battery terminals is bad. See
charge the battery on page 22 .
The blades are loose. See
One or more of the blades are unbalanced. See
24 .
The engine is loose.
To apply and release the parking brake on
To replace the main fuse on page 22 .
To charge the battery on page 22 .
To fill fuel on page 13 .
To replace the air filter, R112C on page 20 .
To replace the air filter, R112C on page 20 .
Battery safety on page 10 .
To examine the blades on page 24 .
To examine the blades on page
To lift and lower the cut-
To charge the
To
1466 - 002 - 28.09.2020