To Replace The Engine Oil; Troubleshooting; Troubleshooting Schedule - Husqvarna R112C Manual De Usuario

To do a check of the engine oil level,
R112C5, R115C
1. Park the product on level ground and stop the
engine.
2. Open the engine cover.
3. Loosen the dipstick and pull it out.
4. Clean the oil from the dipstick.
5. Put the dipstick back in and tighten it.
6. Loosen and pull the dipstick out and read the oil
level.
7. The oil level must be between the marks on the
dipstick. If the level is near the ADD mark, fill oil to
the FULL mark.
8. Fill the oil through the hole for the dipstick. Fill the oil
slowly.
Technical data on page 29 for the types
Note: See
of engine oil that we recommend. Do not mix
different types of oil.
9. Tighten the dipstick correctly before you start the
engine. Start and idle the engine for approximately
30 seconds. Stop the engine. Wait 30 seconds and
do a check of the oil level again.

Troubleshooting schedule

If you cannot find a solution to your problems in this
owner's manual, speak to your Husqvarna service
agent.
1466 - 002 - 28.09.2020

To replace the engine oil

1. Put a container below the oil drain plug.
2. Remove the dipstick.
3. Remove the drain plug.
a) For R112C and R112C5.
b) For R115C.
4. Drain the engine oil into the container.
5. Attach the drain plug and tighten it.
6. Fill with new engine oil. Refer to
engine oil level, R112C5, R115C on page 25 .
7. Install the dipstick.
8. Let the engine become warm, then make sure that
there is no leakage from the oil drain plug.

Troubleshooting

WARNING: Engine oil is very hot directly
after the engine stops. Let the engine
become cool before you drain the engine oil.
If you spill engine oil on your skin, clean with
soap and water.
To do a check of the
25