Bosch GSR18V-535FC Instrucciones De Funcionamiento Y Seguridad página 13

2610055572 GSR18V-535FC 01-2020.qxp_GSR18V-60FC 1/28/20 8:40 AM Page 13
▶ Inserting and Removing Bits
(Main Hex Drive)
after insertion. Loss of control from
loose bit may cause personal injury or
property damage.
Any 1/4" hex bit can be inserted directly
into the main hex drive 1 without using any
of the adapters (Fig. 6).
To insert bit, push locking sleeve 2 back
and insert bit.
To remove a bit, push locking sleeve 2 back
and remove bit.
▶ Inserting and Removing Bits
(Offset Adapter)
after insertion. Loss of control from
loose bit may cause personal injury or
property damage.
Offset adapter 12 has a hex drive 1 that
accepts any 1/4" hex bit (Fig. 7).
To insert bit, push locking sleeve 2 back
and insert bit.
To remove a bit, push locking sleeve 2 back
and remove bit.
▶ Inserting and Removing Bits
(Metal Drill Chuck Adapter)
loosen or tighten bit. Contact with spinning
chuck can cause personal injury.
Move forward/reversing lever 9 (Fig. 1) to
the center "OFF" position. Rotate the clutch
ring 3 to the drill bit symbol
the chuck sleeve counter-clockwise viewing
from chuck end, and open chuck to
approximate drill bit diameter. Insert a clean
bit up to the drill bit flutes for small bits, or
as far as it will go for large bits. Close chuck
by rotating the chuck sleeve clockwise and
securely tighten by hand (Fig. 8).
Ensure bit is locked in
chuck by pulling on bit
Ensure bit is locked in
chuck by pulling on bit
Do not power on drill
while grasping chuck to
. Rotate
SAVE THESE INSTRUCTIONS
2
1
FIG. 6
2
FIG. 7
1
3
FIG. 8
12
11
13