Waeco CoolMatic CRX50 Instrucciones De Montaje página 46

Installing and connecting the refrigerator
➤ Connect your refrigerator to a plug socket which is fuse-protected with at
least 15 A (at 12 V) or 7.5 A (at 24 V) (fig. d 1, page 9).
➤ Connect the red cable (fig. d rt, page 9) to the positive terminal of the
battery.
➤ Connect the black cable (fig. d sw, page 9) to the negative terminal of
the battery.
Connecting the refrigerator to AC voltage
D
DANGER! mortal danger!
 Never handle plugs and switches with wet hands or if you are
standing on a wet surface.
 If you are operating your refrigerator on board a boat with an
AC mains connection using a shore connection, you must
install a residual current circuit breaker between the AC mains
supply and the refrigerator.
Seek advice from a trained technician.
You can connect the refrigerator to 100 – 240 Vw AC power if you use the
MPS 35 rectifier (accessory).
The MPS 35 rectifier features a priority circuit which conserves the battery
connected. When a 100 – 240 Vw mains connection is used, the rectifier
automatically switches from battery to mains operation.
When disconnected from the 100 – 240 Vw mains supply, the rectifier auto-
matically switches back to battery operation. Mains operation via the rectifier
always takes priority over battery operation.
Proceed as follows when you connect the refrigerator to the AC supply:
➤ Attach the rectifier on the back of the refrigerator.
➤ Connect the rectifier as shown in fig. e, page 9.
➤ Connect the refrigerator to the rectifier (fig. e 2, page 9):
– Red cable: positive battery terminal
– Black cable: negative battery terminal
➤ Plug the connector into the AC socket (fig. e 1, page 9).
46
CoolMatic
EN