Changing The Door Hinge - Waeco CoolMatic CRX50 Instrucciones De Montaje

Installing and connecting the refrigerator
 Keep objects clear of openings in the housing or installation structure
(such as ventilation slots, etc.).
 Condensate is produced when the refrigerator is operating normally. You
can either wipe up the condensate in regular intervals, or drain it through
an outlet in the rear of the refrigerator.
Proceed as follows to install the refrigerator:
➤ If you wish to drain the condensate through a hose:
Remove the drain plug (fig. 8 1, page 6).
➤ Connect a hose with an inside diameter of 10 mm to the outlet port
(fig. 8 2, page 6).
➤ Undo the transport lock (chapter "Releasing the lock" on page 50).
➤ Open the refrigerator door.
➤ Remove the blanking plugs (fig. 9 2, page 7).
➤ Push the refrigerator into the recess.
➤ Fix the refrigerator in place using suitable screws (fig. 9 1, page 7).
➤ Press the blanking plugs (fig. 9 2, page 7) into the openings.
7.3

Changing the door hinge

You can also change the hinge of the door, so that it opens to the left rather
than the right.
➤ Proceed as shown in fig. 0, page 7 to fig. b, page 8, to change the
hinges.
44
CoolMatic
EN