Tabla de contenido
Publicidad
i
nStallation
Upon receiving the Ohaus Mini Vortex Mixer, check to ensure that no damage has
occurred during shipment. It is important that any damage that occurred in transport
is detected at the time of unpacking. If you do find such damage the carrier must be
notified immediately.
After unpacking, place the Mini Vortex Mixer on a level bench or table, away from
explosive vapors. Ensure that the surface on which the unit is placed will withstand
typical heat produced by the unit. Always place the unit on a sturdy work surface.
The Mini Vortex Mixer is supplied with a power cord that should be plugged into a
properly grounded outlet. If the supplied power cord does not meet your needs, please
use an approved power cord that suits local codes and electric supply. Replacement
of the plug must be made by a qualified electrician.
m
& S
aintenance
ervicing
The Mini Vortex Mixer is built for long, trouble-free, dependable service. No lubrication
or other technical user maintenance is required.
The unit should be given the care normally required for any electrical appliance. Avoid
wetting or unnecessary exposure to fumes. Spills should be removed promptly. DO
NOT use a cleaning agent or solvent on the front panel which is abrasive or harmful to
plastics, nor one which is flammable. Always ensure the power is disconnected from
the unit prior to any cleaning. If the unit ever requires service, contact your Ohaus
representative.
i
u
ntenDeD
Se
The Ohaus Mini Vortex Mixers are intended for general laboratory use. Safety can not
be guaranteed if used outside of the intended use.
e
c
nvironmental
onDitionS
Operating Conditions: Indoor use only.
Temperature:
4 to 40°C (39.2 to 104°F)
Humidity:
20% to 85% relative humidity, non-condensing
Altitude:
0 to 6,562 ft. (2000 M) above sea level
Non-Operating Storage:
Temperature:
-20 to 65°C (-4 to 149°F)
Humidity:
20% to 85% relative humidity, non-condensing
Installation Category II and Pollution Degree 2 in accordance with IEC 664.
e
D
quiPment
iSPoSal
This equipment must not be disposed of with unsorted waste. It is your responsibility
to correctly dispose of the equipment at life-cycle-end by handing it
over to an authorized facility for separate collection and recycling. It is also
your responsibility to decontaminate the equipment in case of biological,
chemical and/or radiological contamination, so as to protect the persons
involved in the disposal and recycling of the equipment from health
hazards.
For more information about where you can drop off your waste of equipment, please
contact your local dealer from whom you originally purchased this equipment. By doing
so, you will help to conserve natural and environmental resources and you will ensure
that your equipment is recycled in a manner that protects human health.
EN
2
2
Publicidad
Tabla de contenido
