Oase Filtral UVC 700 Instrucciones De Uso página 11

- English -
UVC lamp replacement
Filtral UVC 700 / 1200
Attention! Breakable glass.
Possible consequences: Injury to your hands caused by cuts
Protective measures: Handle the quartz glass and UVC lamp with care..
CAUTION
!
The ultra-violet radiation of the UVC lamp can burn your eyes and skin.
• Never operate the UVC lamp outside its casing.
• Never operate the UVC lamp in a casing that is defective.
Danger: Ultraviolet radiation.
!
Do not expose eyes to lamp rays.
Disconnect power before servicing or replacing lamp.
Replace lamp only with lamp rated 7 watts (UVC 700) 9 watts (UVC 1200):
Warning: To reduce the risk of electric shock - Connect only to a circuit that is protected by a ground-fault circuit
interrupter (GFCI)
For indoor and outdoor household use
● Open the UVC water housing (see
section Opening and cleaning the
UVC water housing).
1. Remove the self-tapping screw (A).
● Unscrew the clamping screw (B) from
the unit head (C) by turning counter-
clockwise.
2. Pull off the quartz glass (D) and the
O-ring while slightly turning the unit
head (C).
3. Pull out the UVC lamp (F) and replace.
● Important: Only use lamps the
identification and capacity data of which
correspond to the information on the
type plate.
● Check the quartz glass (D) and the O
ring (E) for damage.
4. Insert the quartz glass (D) including the
O ring (E) against the stop in the unit
head (C).
5. Tighten the clamping screw (B)
clockwise up to the stop.
● Turn in and tighten the self-tapping
screw (A).
● Close the UVC water housing (see
section Closing the UVC water
housing).
Questions, problems, missing parts?
Before returning to your retailer, call us at 1-866-627-3435, 8 a.m.-6 p.m., EST, Monday-Friday, or email
us at customercare@oase-livingwater.com. Or visit our website at www.oase-livingwater.com
1.
A
D
3.
F
5.
2.
C
D
B
4.
D
B
A
B
C
C
B
C
E
11