Technical Data - brennenstuhl ML DN 2806 S Manual De Instrucciones

Operating Instructions
D
SMD LED Light
ML DN 2806 S / ML DN 4006 S / L DN 2806 S
Please note: Please read these instructions carefully prior to mounting the light and store them
in a safe location afterwards!

TEcHNIcaL DaTa:

Type of protection:
Protection class:
Nominal voltage:
Operating temperature: -20°C – +40°C
Article: Output:
ML DN 2806 S 20 W
ML DN 4006 S 30 W
L DN 2806 S 20 W
PrOPEr INTENDED uSE:
This high-performance LED lamp is for lighting interior and exterior areas.
The LED lamp is delivered, ready to connect, with a connection line and ground contact plug.
All models are spray water-resistant.
When using the lamp outdoors, spray water resistance is only ensured if the EU plug is connected
to an outlet with the same safety class (IPX4).
British standard and Swiss plugs are not spray water-resistant and may only be used indoors.
Any other use than those described above or modifications to the device are not permitted.
OPEraTION:
ML DN 2806 S / ML DN 4006 S
Place on a dry, flat surface. The lamp can be switched on and off using the switch on the rear side.
L DN 2806 S
The lamp can be installed on a suitable tripod. Make sure the tripod is sufficiently stable and the
lamp is securely installed.
Installation height: <3 m
Projection area; 0.03 m²
BA_SMD_LED-Leuchte_0487226_180903_KW36.indd 5
IP 54
I
220 – 240 V~ 50/60 Hz
Power Current
factor: max.:
> 0.5 0.2 A 2 m H05RN-F 3G1.0
> 0.9 0.15 A 2 m H05RN-F 3G1.0
> 0.5 0.2 A 3 m H05RN-F 3G1.0
Connection cable: Dimensions (mm)
194 x 210 x 326.5
194 x 210 x 326.5
194 x 80 x 194
Weight:
1800 g
1800 g
1150 g
5
03.09.18 15:00