Headlamp Bulbs Replacement - Husqvarna WR 250 2011 Manual De Uso Y Mantenimiento

HEADLAMP BULBS REPLACEMENT

- Headlamp with two filaments bulb of 12V-35/35W and park-
ing light bulb of 12V-5W;
- Turn signals bulb of 12V-10W;
To gain access to the healamp bulbs, proceede as follows:
- remove the upper fastening screw of the the headlamp carrier to
the instrument panuel support (A);
- push forward the headlamp carrier (B) and pull it towards the
high (C) in order to uncouple from the two lower supports.
- remove the headlamp carrier;
C
B
- remove the two filaments bulb (7) connector (2) and the boot
(3);
- remove the screw (6);
- release the bulb holding spring (4) and then the bulb itself.
To replace the parking light bulb (5) extract it from the inside
cover.
After replacement, reverse operations for reassembly.
A
5
2
4
5
4
3
3
7
6
EN - 51