Headlamp Bulbs Replacement - Husqvarna TE125 2011 Caracteristicas - Uso - Mantenimiento

HEADLAMP BULBS REPLACEMENT

Proceed as follows to reach the headlamp bulbs:
- Loosen screw (1) and remove the front fairing (2) to-
gether with the headlamp (3);
- detach connector (4) from the bulb;
- slide off the rubber gaiter (5);
- release the bulb holder clips (6) and take out bulb (7);
1
4
Note*:
Headlamp bulb (7) is of the halogen type; be care-
ful when replacing it since the glass part shall not be
touched with bare hands.
To replace the parking light bulb (8) extract it from the
inside cover.
Once the bulb has been replaced, reverse the above pro-
cedure to reassemble.
5
8 6
2
3
7
EN - 37