Location and Function of Parts and Controls
1 (standby) Switch / Indicator
Section
1 1 (standby) switch
Press to turn on the display unit. Press again to go
back to the standby mode.
2 STANDBY indicator
Lights up in red in the standby mode.
When the STANDBY indicator flashes, see "Self-diagnosis
Function" on page 44 (GB).
3 ON indicator
Lights up in green when the display unit is turned on.
4 Remote control detector
Receives the signal from the Remote Commander.
8
(GB)
Control Button Section (Rear)
4
3
2
1
1 MENU button
Press to make the menu appear. When the menu
appears on the display screen, press to return to the
previous menu level. To clear the menu, press this
button repeatedly until the menu disappears.
2 v / V buttons
Press to move the cursor (B) to an item or to adjust a
value in a menu.
3 ENTER button
Press to select the desired item from the menu
displayed.
1
2
3