Restoring The Pic Control Menu Items To Their Original Settings - Sony PFM-42B1 Manual De Instrucciones

Adjusting the Picture
(1) Select a number to register with v / V and
press ENTER.
The cursor (B) appears on the display panel.
(2) Press v / V to move the cursor (B) to the gain
item that you want to set and press ENTER.
The following menu appears on the display
panel.
C O L O R T E M P
R E D G A I N
(3) Adjust the gain (0 to 255) with v / V and
press MENU.
The menu returns to the COLOR TEMP
menu.
The PFM-42B1/42B1E variable range is 10 to 255.
(4) Repeat steps (2) and (3) to set the other gain
items and press MENU.
The menu returns to the COLOR TEMP
menu.
When you rename the adjusted color temperature,
follow the steps below.
(5) Press v / V to move the cursor (B) to "NAME
SET" and press ENTER.
The following menu appears on the display
panel.
C O L O R T E M P
S E T : [ – × ⁄ = ±
N A M E
S E L E C T
(6) Select the character to be changed with v / V
and press ENTER.
The background of a character in the character
list changes to cyan.
28
(GB)
: 1
: 1 2 8
: [ 1 ]
0 1 2 3 4 ]
S E T ENTER E N D MENU
Character list
(7) Select a character in the character list with
v / V and press ENTER.
The selected character is input.
(8) Repeat steps (6) and (7) until you finish
inputting the name, then press MENU.
The menu returns to the COLOR TEMP
menu.
SHARPNESS
You can change the outline correction level to one of
three levels (HIGH, MID or LOW).
1
Press v / V to move the cursor (B) to
"SHARPNESS" and press ENTER.
2
Select the outline correction level with v / V and
press ENTER.
HIGH: sharper picture
MID: standard value
LOW: softer picture
Notes
• CHROMA and PHASE controls do not function with
an RGB signal.
• PHASE control does not function with a component
signal.
• PHASE control does not function with a PAL or
SECAM color source.
• Do not change the CHROMA/PHASE (NTSC only)
level when the selected signal is black-and-white.
Although it has no effect on the current picture, it
does affect the picture of color signals such as NTSC
or PAL which may be input later.
Restoring the PIC CONTROL Menu
Items to Their Original Settings
1
In the PIC CONTROL menu, Press v / V to move
the cursor (B) to "RESET" and press ENTER.
The following menu appears on the display panel.
R E S E T
S E L E C T S E T
: N O
E N D
ENTER MENU