Power Indicator Is Not Lit - Rotel RCD-961 Manual De Instrucciones

Troubleshooting
Most difficulties in audio systems are the re-
sult of incorrect connections, or improper
control settings. If you encounter problems,
isolate the area of the difficulty, check the con-
trol settings, determine the cause of the fault
and make the necessary changes. If you are
unable to get sound from the RCD-961, re-
fer to the suggestions for the following con-
ditions:

Power Indicator Is Not Lit

The Power Indicator and the basic items in
the Display window should be lit whenever
the RCD-961 is plugged into the wall power
outlet and the Power button is pushed in. If it
does not light, test the power outlet with an-
other electrical device, such as a lamp. Be sure
the power outlet being used is not controlled
by a switch that has been turned off.
9
Specifications
Total Harmonic Distortion + Noise
Intermodulation Distortion
Frequency Response (± 0.5 dB)
Channel Balance
Phase Linearity
Channel Separation
Signal to Noise Ratio
Dynamic Range
Digital to Analog Converters
Speed Accuracy, Wow & Flutter
Output Impedance
Digital Output
Load Impedance
Power Requirements
USA Version
European Version:
Power Consumption
Dimensions (W, H, D)
Weight (net)
All specifications are accurate at the 571 -ofe sr vs nhe 5rght o Pmake imp ,verents
0.0045% @ 1kHz
0.0045% @ 1kHz
20-20,000 Hz
± 0.5 dB
± 0.5 degree
> 98 dB @ 1kHz
> 100dB
> 96 dB
18 bit equivalent, multi-level Delta-Sigma DAC with
8x oversampling digital filter and HDCD
Quartz Crystal Precision
100 Ohms
0.5 Volt, Peak to Peak
75 Ohms
AC 115V, 60 Hz
AC 230V, 50 Hz
20 Watts
3 7 7
17 / x 2 / x 12 / inches
8 8 16
440 x 72 x 316 mm
5.4 kg, 11.9 lb.