Upgrading The Wheel Aligner Software; Enabling Extra Wheel Aligner Functions - Corghi EXACT 70 Manual De Uso

Eichstädt Elektronik - Professionelle Kfz-Diagnosegeräte
CONNECTOR CABLE TO
PC OUTPUT BE CONNECTED
KEYBOARD Keyboard cable
PS2 Mouse cable
HHD POwER Power cable
heads/radio card
HHD POwER Power cable
charging rods
POwER Power supply
SUPPLY cable
(**): see instructions above.
N.B.: Some of these outputs may not feature on the
PC you are using.
ATTENTION
For technical specifications, precautions, main-
tenance and all other information concerning
the monitor or printer, refer to the relative op-
erator's manuals supplied with the equipment's
documentation.
Upgrading the wheel aligner
software
The wheel aligner is supplied with the software
already installed, and is complete with an instal-
lation CD-ROM.
After installing the EXACT 70 wheel aligner switch the
equipment on and locate the initial screen.
Press the key combination È+ F12 (upper case +
F12): the software version will appear on the top left
of the screen, beneath the CORGHI logo.
Compare the software release (indicated as "Sw STD
...") with that stated on the installation CD-ROM
supplied with the aligner.
If the CD-ROM release is more recent than the release
installed, update the aligner software.
Detailed information about the software update
procedure is provided in the leaflet accompanying
the CD-ROM.
Operator's Manual EXACT 70
TYPE
Extra wheel aligner functions are enabled by up-
PS2/USB
grading its main protection card, marked with the
socket
PS2/USB
socket
The upgrade is obtained by means of the "upgrade
HHD power card", received when the relative accessory kit is
ordered.
Upgrade cards carry specific identification symbols;
HHD power
detailed information on upgrade identification is
supplied in the leaflets which accompany them.
VDE plugs
To upgrade the main card, which must be inserted
in its slot in the reader, insert the upgrade card
in slot "A" with the gilded contacts facing upward
and run the relative procedure using the
The upgrade card cannot be reused. However, keep
it for use if it becomes necessary to reprogram the
main card of the wheel aligner for which it was used
the first time.
The
the system configuration:
CARD: card number 1 is the wheel aligner's main
card; card number 2 (if any) is an upgrade card.
HEADER: "MAS" aligner main card, "AGG" upgrade
card.
SERIAL: card serial number. For main cards this
number is unique. For upgrade cards the number
is 0 when they are new, while after use it becomes
the same as that of the main card that has been
upgraded.
DATE: card creation date.
VAS: "ON" Vw/AUDI program on, "OFF" program
off.
MLK: "ON" MULTILINK suspension car program on,
"OFF" program off.
REN: "ON" RENAULT program on, "OFF" program
off The RENAULT program reverses the toe signs
for RENAULT vehicles only.
http://www.eichstaedt-elektonik.de
Enabling extra wheel aligner
functions
symbol.
and icons.
, and
,
icons display
EN
53