Others; Troubleshooting/Repair - Nikon RifleHunter 1000 Manual De Instrucciones

Others

En
Fr
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
Es
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
Pt
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules and to EU EMC directive. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the following measures:
•Reorient or relocate the receiving antenna.
•Increase the separation between the equipment and receiver.
•Consult the dealer or an experienced radio/TV technician for help.
This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations.
Do not use the Nikon RifleHunter 1000/Archer's Choice MAX for purposes beyond the limits of its stated accuracy.
20

Troubleshooting/Repair

If your Nikon RifleHunter 1000/Archer's Choice MAX should require repair, please contact your local dealer for
details regarding where to send it. Before doing so, you are advised to consult the Troubleshooting Table below.
Symptom
Unit does not turn
• Depress POWER button.
on — LCD fails to
• Check and replace batteries if necessary.
illuminate
• Be sure that nothing, such as your hand or finger, is
Target range cannot
blocking the laser emission aperture and laser detector.
be obtained
• Be sure that the laser emission aperture and laser detector
are clean. Clean them if necessary.
• Be sure that the target shape and condition is appropriate
to reflect the laser beam.
• Replace battery.
• Be sure to hold the unit steady while depressing the
[- - -] ("Cannot
POWER button.
measure") appears
• Be sure the target is within measuring range (10-915
meters/ 11-1,000 yards for RifleHunter 1000, 4.5-183
meters/ 5-200 yards for Archer's Choice MAX)
• Be sure that nothing, such as leaves or grass, is between
Closer target cannot
the Nikon RifleHunter 1000/Archer's Choice MAX and the
be measured
target.
Target beyond a
• Be sure that nothing, such as leaves or grass, is between
certain distance
the Nikon RifleHunter 1000/Archer's Choice MAX and the
cannot be measured
target.
Check Points
En
Fr
Es
Pt
21