Descargar Imprimir esta página

Others; Troubleshooting/Repair - Nikon PROSTAFF 7 Manual De Instrucciones

Ocultar thumbs Ver también para PROSTAFF 7:

Publicidad

Idiomas disponibles

Idiomas disponibles

Others

En
Es
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
Fr
(2) This device must accept any interference received, including interference that may cause undesired operation.
Pt
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules and to EU EMC directive. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
 • Reorient or relocate the receiving antenna.
 • Increase the separation between the equipment and receiver.
 • Consult the dealer or an experienced radio/TV technician for help.
This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations.
This Nikon Laser Rangefinder is a basic rangefinder. Its results cannot be used as official evidence.
20

Troubleshooting/Repair

If your Nikon Laser Rangefinder should require repair, please contact your local dealer or the store where you
purchased it. Before doing so, you are advised to consult the Troubleshooting/Repair Table below.
Symptom
Depress POWER ON/Measurement button. (near side, top of the body)
Unit does not turn on
Check the battery insertion
(LCD fails to illuminate)
Replace the battery with a new one.
Be sure that nothing, such as your finger or a strap, is blocking the laser
emission aperture and laser detector aperture on the objective lens
side.
Be sure that the laser emission aperture and laser detector aperture on
Unable to measure the distance
the objective lens side are clean. Clean them if necessary.
Be sure that the target shape and condition are appropriate to reflect
the laser beam.
Replace the battery with a new one.
Be sure to hold the unit steady while measuring.
[- - -] ("Cannot measure") appears
Be sure the target is within measurement range
Measurement range: 4.5-550m/5-600 yards
Closer target, located inside the
Be sure that nothing, such as leaves or grass, is between the Nikon Laser
measurement range, cannot be
Rangefinder and the target.
measured
Target beyond a certain distance
Be sure that nothing, such as leaves or grass, is between the Nikon Laser
cannot be measured
Rangefinder and the target.
Replace the battery with a new one.
Be sure that the target shape and condition are appropriate to reflect
the laser beam.
Measurement result is unstable
Be sure to hold the unit steady while measuring.
Be sure that nothing, such as leaves or grass, is between the Nikon Laser
Rangefinder and the target.
En
Es
Fr
Pt
Check Points
21

Publicidad

loading