Setting The Discharge Current; Starting A Charge / Discharge Process - ROBBE Compact 6S EQ Duo Power Manual De Uso

SETTING THE DISCHARGE CURRENT

Press the '+' button to leaf through the screen display until the arrow indicates Discharge
button. Press the 'ENTER' button again to confirm your selection. The available discharge
current range is 0.1 A to 1.0 A, although the maximum current value varies according to
the cell count and / or the battery voltage. The charger's integral processor limits the
maximum discharge current.
SETTING THE AUDIBLE SIGNAL
Press the '+' button to leaf through the screen display until the arrow indicates Beeper.
charge process is finished. Five different sounds are available, and the beeper can also be
switched off. Pressing the '+' or '-' button cycles through the available sounds; at the
same time the charger emits the corresponding sound once to help you select your prefe-
rence.
STORING THE SETTINGS
entered. The screen now reverts to the Start display, i.e. it returns to the starting point.
7.4 STARTING A CHARGE OR DISCHARGE PROCESS
• Press 'MAN', and the Start display appears.
Operating instructions
Compact 6S EQ Duo Power
Current. Press the 'ENTER' button and the '+ / -'
symbol flashes. You can now select the discharge
current in increments of 0.1 A using the '+' or '-'
Press the 'ENTER' button and the '+ / -' symbol
flashes. You can now select the sound which the
charger emits, for example, to alert you that the
Press the '+' button to leaf through the screen dis-
play until the arrow indicates End, then press the
'ENTER' button to store the settings you have just
• Press 'ENTER' to prepare the displayed memory
for the charge process.
• Select the desired process by pressing the
'MODE' button.
• In the interests of safety the screen displays the
stored parameters again.
• Press the 'START' button to initiate the charge
process; an audible beep confirms your action. The
screen now changes to a working display, which
shows all the important parameters (see Chapter
5.1).
• During the process you can change the current
using the '+' or '-' buttons; the new value flashes
initially before the charger adopts it.
15
Order No.
8506