Mounting The Gearbox - Stihl KW-KM Manual De Instrucciones

Mounting the Gearbox

2
1
3
Connecting drive tube to gearbox
:
Loosen the clamp screw (1).
:
Remove the protective caps from
the ends of the tube and put them in
a safe place.
: Push the gearbox (2) onto the drive
tube (3), turning the gearbox back
and forth at the same time.
KW-KM
4
: Once the end of the drive tube is
inserted beyond the slot in the
clamp (4) – ease the rubber sleeve
to one side to check this – push the
gearbox right up to the stop.
Fit the clamp screw as far as stop.
English / USA
3
5
: Line up the gearbox (2) on the drive
tube (3) so that the fixing lug on the
drive tube (arrow) points vertically
upward when the output shafts (5)
are horizontal.
:
Tighten the clamp screws firmly.
:
Go to "Mounting Sweeper Drums".
:
Mount the CombiTool on the
CombiEngine – see "Mounting the
CombiTool".
5
2
11