Replacing The Rubber Sleeve; Removing The Gearbox - Stihl KW-KM Manual De Instrucciones

English / USA
Replacing the
Rubber Sleeve
The rubber sleeve protects the drive
tube from wear caused by contact with
the sweeper belts.
A worn sleeve must be replaced as
follows:
: Remove the sweeper drums –
:
see "Replacing Sweeper Drum".
:
Remove the gearbox –
see "Removing the Gearbox".
: Pull the worn sleeve off the gearbox.
16
: Push a new sleeve onto the
gearbox.
: Mount the gearbox – see "Installing
the Gearbox".
:
Fit the sweeper drums – see
"Mounting Sweeper Drums".

Removing the Gearbox

: Straighten the ends of the cotter pin,
remove the cotter pin.
: Pull the sweeper drum off the shaft.
:
Examine gear housing for signs of
oil. If leaks are found, have your
STIHL dealer check the gearbox.
:
Repeat the above procedure on the
other side.
1
3
: Release the clamp screw (1).
: Pull the gearbox (2) off the drive
tube (3).
2
KW-KM