Mounting the CombiTool
2
1
4
3
:
Engage lug (1) on drive tube in
slot (2) in the coupling sleeve and
push home the drive tube as far as
stop.
:
When correctly installed, the red
line (3) (arrow point) must be flush
with the end of the coupling sleeve.
:
Tighten the wing screw (4) firmly.
Reverse the above sequence to remove
the drive tube.
KW-KM
Fitting the Harness*
2
Shoulder Strap
:
Put on the shoulder strap (1).
:
Adjust length of strap until the spring
hook (2) is about a hand's width
below your right hip.
:
Balance the PowerSweep –
see "Balancing the Machine".
*
See "Guide to Using this Manual"
Balancing the Machine
1
Attaching Machine to Harness*
:
Attach the spring hook (1) to the
clamp* (2).
*
See "Guide to Using this Manual"
English / USA
2
1
1
2
13