Installation - ABB 8186/03-500 Manual De Instrucciones

Installation

Power Supply PoE
1 To install the Power
Supply PoE to the Patch
Panel PoE, connect the
terminal U (+ and -) by
aus
an installation cable with
"+" and "-" of the Patch
Panel PoE after opening the
housing.
2 Connect the 230 V-supply
at the screw terminals L
and N. The green LED
lights up when the 230
V-supply is connected.
3 We recommend a separate
circuit breaker for the power
supply in the electrical dis-
tribution box.
Figure 2
Figure 3
Patch Panel PoE
1 Plug the patch cable in the
RJ45 ports on the front
face and connect them
with the active network
components
(s. fig. 2).
2 For the disconnection of
the patch cables from the
terminals press the release
knob above of the respec-
tive port at first and then
extract the plug from the
outlet (s. fig. 3).
15