Operation - Unold 86895 Instrucciones De Uso

3. Check whether all needed parts
are present.
4. Have the support feet (12),
the wind screws (13) and the
connecting rods (14) ready.
5. Slide one of the three holders over
each of support foot.
6. A connection rod (14) must
be placed between each of the
supporting feet and fastened
with the wing screws (13) (see
illustration).
7. Slide the rubber ring (10) over
the lower end of the support tube
(9) and insert the support tube
into the intended opening on the
frame (12). In this process the
recess on the support tube must
point to the bore on the frame.
8. Fix both components in place
with the locking screw (11).
9. Remove the screw from the (5)
motor.
10. Fasten the lower basket cover on
the motor housing; the carrying
handle on the basket cover must
point upward. Align the basket
cover to the four openings on the
motor. The holes provided on the

OPERATION

1. Ensure that the appliance is stan-
ding on a suitable, level subst-
rate, and has been set up so that
it is safe and stable.
2. Plug the power cord into an elec-
trical outlet.
Setting the speed
3. Switch on the appliance by selec-
ting one of the three speed levels
and setting the selected speed
level via the speed regulator:
Copyright UNOLD AG | www.unold.de
cover must be aligned precisely
above the bores on the motor
housing. Fix the cover in place
with the screw (5).
11. Remove the screw from the (4)
impeller.
12. Fit the impeller on the axle and
fix it in place with the screw (4).
In this process the impeller must
not be fitted entirely over the axle
but rather must seal flush with
the axle on the front. Fasten the
impeller with the screw, this must
be fixed in place on the flattened
side of the axle.
13. Ensure that the impeller does not
touch the basket cover, before you
proceeding.
14. Connect the front basket cover to
the rear basket cover, by hooking
the hook of the front basket cover
into the groove on the rear basket
cover, (groove and hook are each
located at the bottom on the
basket covers!)
15. Fix the two basket covers in place
by closing the clamps on the edge.
ƒ Level 1: Light breeze
ƒ Level 2: Moderate breeze
ƒ Level 3: Strong breeze
ƒ The regulator
switches off the appliance.
4. You can change between the dif-
ferent speed levels at any time.
Swing function/oscillation function
5. Press the oscillation button on the
rear of the appliance head down-
ward (see illustration). The appli-
position "0"
17