Orbegozo CA 09160 BL Manual De Instrucciones página 13

CA 09160/90 BL
2. Press once and the lights will turn on. Press
3. Press , it will light and the hood will run at low speed. Press again to stop it.
4. Press , it will light up and the hood will run at medium speed. Press again to stop it.
5. Press , it will light up and the hood will run at high speed. Press again to stop it.
6. While the hood is working, pressing the timer button
turn off automatically.
MAINTENANCE
- The hood and filter should be regularly cleaned to keep it in good condition. Since the grease filter is
metal, do not clean it with detergents that could corrode it. Please clean it in the following ways:
O Put the filter in hot water (40-50 ° C) with a little degreasing detergent and leave it for 2-3 minutes and
then wipe it with a soft brush. Do not brush very hard as this may damage the filter.
O Put the filter in the dishwasher with detergent and select a temperature of 60 ° C.
- To protect the hood from corrosion for a long period of time, clean it once a week with a cloth dampened
with hot water and non-abrasive detergent.
- Keep the engine and other electronic parts away from the water, if they get wet they could be damaged.
- Assembly and disassembly of the filter as shown in the drawing:
CARBON FILTER (NOT SUPPLIED)
1. Remove the aluminum filter.
2. Place the activated carbon filter on one side of the engine and turn counterclockwise. Repeat the same
operation on the other side.
NOTICE:
- Make sure that the filter is correctly positioned. Otherwise, it may loosen to damage the motor of the
again and the lights will turn off.
, will cause the hood to work for 5 minutes and
13