Orbegozo CA 09160 BL Manual De Instrucciones página 14

CA 09160/90 BL
hood.
- When the carbon filter is in place suction power will be reduced.
- This filter cannot be washed or reused. It should be changed every 3 to 6 months depending on usage.
PROBLEM SOLVING
PROBLEM
The lights do not
work but the engine
works
Lights work but
engine does not run
Lights and engine do
not work
The Hood vibrates
excessively
Insufficient suction
Disposal of old electrical appliances.
The European directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE), requires
that old household electrical appliances must not be disposed of in the normal unsorted municipal
waste stream. Old appliances must be collected separately in order to optimize the recovery and
recycling of the materials they contain, and reduce the impact on human health and the environment. The
crossed out "wheeled bin" symbol on the product reminds you of your obligation, that when you dispose of
the appliance, it must be separately collected.
Consumers should contact their local authority or retailer for information concerning the correct disposal of
their old appliance.
DECLARATION OF CONFORMITY: This device complies with the requirements of the Low Voltage
Directive 2014/35/EU and the requirements of the EMC directive 2014/30/EU.
CAUSE
The bulb is broken
The bulb connection does not work properly
The button on the control panel is damaged
Damaged engine bearings
Engine is burned
Damaged engine control button
Hood's plug is damage
Damage / cut cable
Damage connection button
Output valve damaged
Motor screw loosened
Hood improperly fitted to the cabinet
The distance between the hood and the
cooking surface is too great.
The ventilation in the room is very strong or
the kitchen is very closed
The extraction tube is very long
The air outlet valve is not open
The wind on the outside is very strong
SOLUTION
Change the bulb
Repair or replace
Repair or replace
Replace engine
Replace engine
Repair or replace
Repair or replace
Replace the cable
Repair or replace
Repair or replace
Tighten the screw
Adjust and tighten the screws
Readjust the distance
Reduce the ventilation or open a
window
Adjust the length of the tube
Check whether the valve is flexible
It is not a technical problem
14