Troubleshooting; Transportation And Storage - Greencut EB400L Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

44

TROUBLESHOOTING

The table includes some of the most common problems, their causes and remedies.
PROBLEM
POSSIBILE CAUSE
• The battery is not in contact.
The unit
• The battery is not correctly
does not
installed.
work
• Battery not charged.
• Battery not inserted in the
charger.
The battery
• The charger is not plugged in.
does not
• Air temperature too hot or
charge
too cold.
Low power
• The battery is uncharged.
NOTE: If you are unable to resolve the problem, please contact the Official Technical Service.

TRANSPORTATION AND STORAGE

Always disconnect the battery from the machine before transporting it.
Transport the battery in accordance with local and national and local regulations.
Follow all special packing and labelling requirements when transporting batteries for a third party.
Ensure that no battery can come into contact with other batteries or conductive materials during transport by
protecting the exposed connectors with non-conductive insulating caps or tape.
Do not transport batteries that are cracked or leaking.
Store the battery and charger separately in a dry place, free of moisture and frost.
Do not store the battery in places where static electricity can be generated. Never transport the battery in a
metal box.
Store the battery in a place away from extreme temperatures, and away from direct sunlight.
Store the charger only in a closed and dry place.
All batteries gradually lose their charge. Recharge the batteries every 3 months.
When your cordless blower is not in use, it should be stored in a dry and high place or locked, out of the reach
of children.
• Check that the battery is fully inserted.
• Check that the battery is connected correctly.
• Check the battery charging requirements.
• Insert the battery into the charger until the LED is lit up.
• Plug the charger into a working outlet.
• Check the current in the receptacle by plugging in a lamp or
other device.
• Check if the receptacle is connected to a switch that turns off
when the lights are turned off.
• Move the charger and tool to a surrounding air temperature
above 50 degrees F (10 degrees C) or below 100 degrees F
(+37.8 degrees C).
• Charge the battery.
SOLUTION

Publicidad

Tabla de contenido
loading

Tabla de contenido