Maintenance; Troubleshooting - Greencut EB560L Manual De Instrucciones

MAINTENANCE

Good maintenance will extend the life of the machine. Prolonged or constant use may require more intensive
maintenance for the machine to continue to function properly.
ATTENTION: Make sure the engine is completely shut down before performing any maintenance
or repair. This will eliminate any potential risk.
• Spare parts must be purchased from the Official Technical Service.
• Keep the machine clean, especially the engine ventilation windows.
• Clean the housing of your machine with a cloth moistened in water.
• Never use gasoline, solvents, detergents, water or any other liquid to clean the machine.
• Periodically check that the charger and the battery are intact.
• Like all rechargeable batteries, after use time, it will be necessary to replace it.
• Keep the charger clean, especially the battery connections. Dirt can cause electric shock and / or fire.
NOTE: To guarantee the safety and reliability of the machine, repairs, maintenance and adjustments
must be made by the Official Technical Service and always using original spare parts.

TROUBLESHOOTING

The table includes some common problems, their causes and solutions.
POSSIBLE CAUSE
PROBLEM
• Battery not making contact.
Unit does
• Battery not installed properly.
not run
• Battery not charged.
• Battery not inserted into charger
Battery will • Charger not plugged in.
not charge • Surrounding air temperature too
hot or too cold.
Low
blowing • Battery not charged.
power
NOTE: If you are unable to resolve the problem, please contact the Official Technical Service.
SOLUTION
• Check battery is fully inserted.
• Check that battery is securely connected to the blower.
• Check battery charging requirements.
• Insert battery into charger until LED appears.
• Plug charger into a working outlet.
• Check current at receptacle by plugging in a lamp or other
appliance.
• Check to see if receptacle is connected to a light switch which
turns power off when you turn out the lights.
• Move charger and tool to a surrounding air temperature of
above 50ºF (10ºC) or below 100ºF (+37.8ºC)
• Charge the battery.
39
EN