Vortice ECODRY Manual De Instrucciones página 16

ENGLISH
system.
• Regularly inspect the appliance for visible defects.If any faults are found, do not operate the appliance but contact
Vortice immediately.
• If the appliance malfunctions or develops a fault, contact Vortice* immediately. Ensure that only genuine Vortice
spares are used for any repairs.
• Should the appliance be dropped or suffer a heavy blow, have it checked immediately by Vortice.
• The appliance must be isolated from the electricty supply: a) if the appliance does not function correctly; b)
before cleaning the outside of the appliance, c) if the appliance is not to be used for any length of time.
• Electrical wiring must be done by qualified person(s) in accordance with all applicable codes and standards,
including fire-rated construction.
• Do not use the backplate as a guide when drilling. Ensure no pipe work (gas, water, air) or electrical cables,
wires or ductwork are located directly behind the drilling/mounting area
• Check that the electrical power supply provides the maximum electrical power required by the appliance. If it
cannot do so, arrange for a qualified electrician to make the necessary modifications.
• Specifications for the power supply must correspond to the electrical data on ID plate A.
ECODRY
The appliance must be installed by a qualified electrician.
•
Ensure that the electrical system to which the appliance is connected
•
complies with applicable standards.
The appliance must be wired to the power supply by way of a multi-
•
pole isolating switch with a gap of at least 3 mm between contacts.
N.B.
• The device is equipped with a button (accessible by removing the front cover fig.8) which excludes the
electrical resistance, with a power of 400 W
• The device is equipped with a auto reset safety device against 120°C.
• The automatic appliance is equipped with a device that interrupts the power supply after 50 seconds of
continous operation.
• Whenever possible, it is recommended that the automatic appliance be fitted well away from radiators
or other heating equipment, so as to avoid the risk of heat compromising proper operation of the
electronic components.
16
ECODRY EC