Vortice ECODRY Manual De Instrucciones página 24

ENGLISH
6. Turn power ON and after 5 second power, turn OFF again. (IMPORTANT RESET FUNCTION, if this action
is not performed the LED will continue to flash)
7. Insert the New Filter into filter case and reassembly to the main body.
The dot on the filter cover is aligned with the arrow on the motor cover (fig. 13)
13
8. Turn the filter cover to close direction. The dot is positioned to the right of the arrow on the motor cover
(fig. 11A).
9. Assembly the front cover to the backplate and tighten the two screws(fig. 9)
10. Turn power on.
11. Test unit for correct operation.
12. When a new filter has been correctly installed, the LED blinks 5 times with an orange light after the power
supply has been connected.
13. The LED light returns white when the filter has been correctly replaced.
Note: If the LED does not blink, the LED light remains off and the filter must be reinstalled correctly.
Warning - If the filter is not replaced on time, it may be a progressive air flow reduction and a
consequent overheating of the motor. In this case, the warranty will be invalidated.
The filter must be replace every 3-6 months to avoid invalidating the warranty period.
Absolutely do not re-use the used filter. The filter works for 20,000 uses, after this it should
be disposed of and replaced by another filter. Do not install the filter cover if the cover is wet
or damp, it must be perfectly dry. If the cover is installed wet it cancause serious motor
damage and the warranty will be invalidated.
24