First Use; Switching On The Collar; Switching Off The Collar; Changing Mode - Num'axes CANIBEEP Manual De Instrucciones

First use

Fit the battery in the collar:
- unscrew the screw of the cover using a screwdriver or a coin.
- insert the battery (3V lithium CR2) paying attention to follow polarity indicated on
the battery housing (blue arrow)
- a beep sound (low pitch) of 1 second is emitted,indicating that the collar is ready to use.
- put the lid back in place, making sure that the sealing gasket is in the correct
position, and screw the screw all the way, so CANIBEEP is tight.
Now you are ready to use your CANIBEEP .

Switching On the collar

With the magnetic key, touch the position indicator (see diagram 1) for at least
1 second. You will hear two low pitch beeps, indicating that CANIBEEP has been
switched On. Move the magnetic key away.

Switching Off the collar

Touch the position indicator (see diagram 1) with the magnetic key for at least 1
second. You will hear one low pitch beep, indicating that the CANIBEEP has been
switched Off. Move the magnetic key away.

Changing mode

CANIBEEP allows you to locate one to four dogs at the same time (with four different
tones), either when they are pointing, or when they are moving or pointing.
To change the tone emitted by your CANIBEEP or to change mode, when turning it on,
leave the magnetic key on the position indicator.
The collar emits a number of beeps (from 1 to 8, medium pitch tone). Keep the
magnetic key in contact with the position indicator, to run through modes. Move the
key away as soon as you have reached the desired mode: the collar will memorize
the configuration chosen. The next time you turn it on, CANIBEEP will be in the mode
you selected last.
17