Checking/Replacing Battery - Num'axes CANIBEEP Manual De Instrucciones

Caution: The adjustment system has a stop for the minimum sensitivity and a stop for
the maximum sensitivity. Use the screwdriver supplied with CANIBEEP , turn delicately
and without forcing.

Checking/replacing battery

The condition of the battery can be checked in 3 distinct cases: when you insert the
battery, when you turn the collar on and when the collar is deactivated.
After these, if there are 6 low pitch beeps (instead of 1 low pitch beep); your battery
is weak.
Replace the old battery with a new one (3V lithium CR2) paying attention to follow
polarity indicated on the battery housing (blue arrow).
If no beep is emitted after having inserted the battery, remove the battery again and
check that the polarity is correct.
When you put the lid back in place, make sure that the sealing gasket is in the correct
position, and screw the screw all the way, so CANIBEEP is tight.
19