Building Instructions - Multiplex Movie Star Pico line Instrucciones De Montaje

página de 36

/ 36
Contenido
Tabla de contenido
Marcadores

Tabla de contenido

Idiomas disponibles

MovieStar

1. Examine your kit carefully!

MULTIPLEX models are subject to constant quality checks throughout the production process, and we sincerely hope that

you are happy with the contents of your kit. However, we would ask you to check all the parts before you start construction, with

reference to the parts list, as we cannot exchange components which you have already worked on. If you find any part is not

acceptable for any reason, we will readily correct or exchange it once we have examined it. Just send the component to our

Model Department. Please be sure to include a brief description of the fault.

We are constantly working on improving our models, and for this reason we must reserve the right to change the kit contents

in terms of shape or dimensions of parts, technology, materials and fittings, without prior notification. Please understand that

we cannot entertain claims against us if the kit contents do not agree in every respect with the instructions and the illustrations.

Caution!

Radio-controlled models, and especially model aircraft, are by no means playthings in the normal sense of the word.

Building and operating them safely requires a certain level of technical competence and manual skill, together with

discipline and a responsible attitude at the flying field. Errors and carelessness in building and flying the model can

result in serious personal injury and damage to property. Since we, as manufacturers, have no control over the

construction, maintenance and operation of our products, we are obliged to take this opportunity to point out these

hazards, and to emphasise your personal responsibility.

Additional items required:

Radio control system components:

PiCO "Brick" (2 servos, 1 receiver, 1 switch in block)

Elevator / rudder

PiCO Control 400 Duo speed controller

Alternatively:

MULTIPLEX Micro IPD receiver

MULTIPLEX MS-X3 servo (2 reqd.), ele./rudd.

PiCO-Control 400 Duo speed controller

Flight batteries:

MULTIPLEX 7/1700 SCR drive battery

or MULTIPLEX 8/3000 SCR-C drive battery

If you intend flying the model with an additional payload we recommend using eight cells; you may need to arrange them

four cells above four cells to obtain the correct CG. We also recommend the optional gearbox conversion set, Order No.

33 2693.

Battery charger:

PiCO AUTO-Lader for fast-charging transmitter and flight packs

Adhesives:

MULTIPOXY 5-Minute epoxy 100 g, or similar product

MULTIPLEX ZACKI, medium-viscosity

10 g (cyano-acrylate), or similar product

MULTIPLEX Activator, or similar product

Tools:

Scissors, combination pliers, balsa knife, screwdrivers (flat blade and cross-point), 120-grit abrasive paper, 2.5 and 7

mm Ø twist drills.

Specification:

MOVIE STAR

Wingspan

Fuselage length

Wing area (FAI) approx.

Weight approx.

Wing loading

Wing section

Tailplane section

Controls:

Important information - gluing foam components:

The "MOVIE STAR" model is not made of styrofoam but ELAPOR! As adhesives we recommend cyano-acrylate ("cyano")

and contact cement such as UHU Kraftkleber or UHU POR. 5-minute epoxy should only be used in conjunction with a

coupling layer of cyano, with a sprinkling of micro-balloons. Cyano should always be used together with cyano activator.

Parts to be joined are wetted on one side with activator, which is then allowed to air-dry. Cyano (medium-viscosity type)

is applied to the opposite side, and the parts brought together. White glue is not suitable, and epoxy-based adhesives

should not be used without the coupling layer.