Setting Saw To Make A Miter Cut - Bosch CM10GD Instrucciones De Funcionamiento Y Seguridad

BM 2610027879 07-13_BM 2610027879 07-13.qxp 7/8/13 9:52 AM Page 38
Miter cutting 5-1/4" base boards – This saw can
miter cut 5-1/4" tall base boards vertically positioned
against the fence at any angle from 0° to 52°. All
angled cuts must be made with the base board
placed on the left side of the table. For certain cuts,
the base board will have to be flipped upside down or
placed with the face side against the fence. Always
use a C-clamp to hold the base board to the fence
before making cuts. NOTE: For cutting standard
base board up to 4-1/4" tall, no special placement is
required and it can be miter cut at any angle left or
right.
Clamp
Saw Operations
Miter Cuts
Workpiece
figure 46

Setting Saw to Make a Miter Cut

1. See Using Miter Detent on page 33.
2. Loosen the miter lock knob. Lift miter detent lever
and move the saw to the desired angle, using
either the detents or the miter scale. Tighten miter
lock knob (see Figure 47).
3. Properly position workpiece. Make sure workpiece
is clamped firmly against the table or the fence.
Use a clamping position that
WARNING
does
operation. Before switching "ON" saw, lower saw
head to make sure the clamp clears guard and
head assembly.
4. Follow procedures for either chop cut or slide cut
(see pages 34-35).
5. Wait until saw blade comes to a complete stop
before returning head to the raised position and
then remove workpiece.
Clamp
Workpiece Miter Scale Detents
figure 47. Miter Cut
38.
not interfere with
Miter Lock Knob