Indicator Lamp - Makita MU04 Manual De Instrucciones

Overdischarge protection
When the battery capacity is not enough, the tool stops automati-
cally. If you turn the tool on, the motor runs again but stops soon. In
this case, remove the battery from the tool and charge the battery.
Switch action
WARNING:
Before installing the battery car-
tridge into the tool, always check to see that the
switch trigger actuates properly and returns to
the "OFF" position when released.
WARNING:
For your safety, this tool is equipped
with the lock-off button which prevents the tool from
unintended starting. Never use the tool if it starts when
you pull the switch trigger without pressing the lock-off
button. Ask your local Makita Service Center for repairs.
WARNING:
Never disable the lock function or
tape down the lock-off button.
NOTICE:
Do not pull the switch trigger forcibly with-
out pressing the lock-off button. The switch may break.
► 1 . Switch trigger 2. Lock-off button
To start the tool, press the lock-off button and pull the
switch trigger. Release the switch trigger to stop. The lock-
off button can be pressed from either the right or left side.

Indicator lamp

The indicator lamp blinks or lights up when the remain-
ing battery capacity is low or empty. The indicator lamp
also lights up when the tool becomes overloaded.
1
► 1 . Indicator lamp
2
1
Lamp status and action to be taken
Indicator lamp
The lamp blinks
red.
The lamp lights up
red. *
* The time at which the indicator lamp lights up varies depending
on the temperature around the work area and the battery car-
tridge conditions.
Adjusting the shearing height (for
grass shear)
CAUTION:
When changing the shearing
height, be sure to attach the blade cover and be
careful not to trap fingers between the tool and
grass receiver.
The shearing height can be set to three levels (15 mm
(9/16"), 20 mm (13/16"), and 25 mm (1")) by changing
the fixed position of the grass receiver. The shearing
height without the grass receiver is about 10 mm (3/8").
1. Slide the grass receiver toward the front of the tool.
► 1 . Grass receiver
2. Change the fixed position of the grass receiver by
moving it in the direction of the arrow.
7 ENGLISH
Status Action to be taken
The remaining Charge the battery.
battery capacity
is low.
The tool has Charge the battery.
stopped because
the remaining
battery capacity is
empty.
The tool has Turn off the tool.
stopped due to
overload.
1