Using Rear Audio/ Video Input Jacks; Using Audio Output Jacks - Sanyo AVM-2751S Manual Del Propietário

USING THE REAR AUDIO / VIDEO INPUT JACKS
CONNECTING A VCR OR OTHER EXTERNAL EQUIPMENT
Switch off TV and external equipment before connecting cables. (Cables are not supplied.)
1. Connect VCR or other equipment's Audio Out (R/L) to the TV Audio Input (R/L)
For Mono VCR (Single Audio Jack) connect VCR Audio Out to TV
Audio (L) In.
2. Connect VCR or other equipment's Video Out to the TV Video In
3. Press POWER
to turn on the TV. Turn on external equipment also.
4. Press the INPUT key
equipment you have connected to the A/V jacks.
BACK VIEW OF VCR
A/V JACKS
IN
RF
R- AUDIO
CHANNEL
CH3 CH4
OUT
R- AUDIO
USING THE AUDIO OUTPUT JACKS
CONNECTING A STEREO AMPLIFIER TO AUDIO OUT JACKS
1. Connect the TV Audio Out (R/L)
2. Press POWER to turn on the TV. Turn on external equipment also.
STEREO AMPLIFIER
to select program source: TV signal or signal from the
-L VIDEO
-L VIDEO
TV A / V INPUT REAR JACKS
AUDIO
AUDIO VIDEO INPUT
OUTPUT AV2
VIDEO
(MON0)
L L
AUDIO
R R
to the Stereo Amplifier In (R/L)
.
REMOTE CONTROL
POWER
INPUT
MENU
CH
VOL
UHF/VHF/CATV
75Ω
MUTE
.
UHF/VHF/CATV
AUDIO AUDIO VIDEO INPUT
OUTPUT
AV2
VIDEO
(MON0)
L L
AUDIO
R R
BACK OF TV
QuickTips
Make sure all cable
connectors are fully
.
seated on jacks.
Always match cables
according to the
colors;
audio,
audio and
video.
A solid Blue screen
with the words Video
displayed means that
RESET
the Video mode is
selected, but no
RECALL
signal is being
detected at the
VOL
Video jack.
Position your TV at
DISPLAY
least 2 feet from
stereo speakers. The
magnets in the speak-
ers may affect the
picture quality.
Do not connect
external speakers
directly to the TV.
75Ω
for right
RED
for left
WHITE
for
YELLOW
9