Front Panel; Rear Panel; Remote Control - Sanyo AVM-2751S Manual Del Propietário

FRONT PANEL

VIDEO IN L- AUDIO -R

REAR PANEL

Audio/ Video Input Jacks (AV2)
Connect external video equipment
here (see page 9).
Audio Output Jacks (Fixed)
Connect external audio
equipment here (see page 9).

REMOTE CONTROL

INSTALLING BATTERIES (2 AAA not included)
1. Remove the battery cover by pressing the tab and tilting the cover upward. Insert batteries.
Make sure you match
2. Replace battery cover. The remote control is ready!
Notes:
– Do not mix old batteries with new ones or mix
different types of batteries together.
– Remove the batteries if the remote control will not be used
for a month or more. Weak batteries may leak and cause
damage.
IMPORTANT NOTE: Spent or discharged batteries must be recycled or
disposed of properly in compliance with all applicable laws. For detailed
information, contact your local County Solid Waste Authority.
CH CH
MENU MENU
Audio /Video Input Jacks (AV1)
Connect external video equipment
here (see page 8).
AUDIO
OUTPUT
L
R
+
/ signs on the batteries with marks inside the remote control.
MT S
POWER
CH CH VOL VOL VOL VOL
UHF/VHF/CATV
AUDIO VIDEO INPUT
AV2
VIDEO
L (MON0)
AUDIO
R
Cable / Antenna Input
Terminal (75 ohms)
QuickTips
Make sure all cable
connectors are fully
seated on jacks.
See pages 8~9
before connecting
external video
equipment.
Cables are not
supplied for connect-
ing your external
equipment.
A solid Blue screen
with the word Video
75Ω
displayed means that
the Video mode is
selected, but no signal
is being detected at
the Video jack.
Check connection,
and turn on external
equipment.
Be sure batteries are
installed correctly.
Point the remote
control toward the
equipment you want
to operate. Objects
between the remote
control and the
equipment may cause
misoperation of the
remote control
function.
5