Remote Control Keys - Sanyo AVM-2751S Manual Del Propietário

QuickTips
Make sure batteries
have been installed
correctly.
Cannot select channel
with number keys.
Press "0" in front of
numbers 1 ~ 9.
Example: Channel 05.
The "C" in front of the
channel number indi-
cates a Cable channel.
Adjusting the volume
level: Right flashing
arrow indicates
volume is increasing
and left flashing arrow
indicates volume is
decreasing.
Channel number will
not display continu-
ously when captioning
is on.
Using V-Guide TV
Parental Guidelines
settings can be
changed only by using
the Remote Control.
See pages 12 ~ 13.
6

REMOTE CONTROL KEYS

Point towards TV
POWER
GAME
(INPUT)
MENU
CH
VOL
MUTE
2
1 2
1
4
4 5
5
7 8
7 8
CAPTION
0
0
V-GUIDE
Input Key
Press to select the program source to
be displayed on the screen: TV signal
or signal from the equipment you
have connected to the A/V jacks.
Menu Key
Use this key with the
/ keys to navigate and adjust
features of the on-screen menu system
(see pages 7 ~ 8).
Channel (CH) Scanning (
and Volume (
Press to scan through the channels in
RESET
memory and to adjust the volume.
Mute Key
RECALL
Press once to minimize the volume.
Press again to restore.
Note: When using the audio out jacks
VOL
this key will not mute the sound.
Number Keys
Two keys must be pressed to select a
DISPLAY
channel. Example: Press 0 then 6 to
11
select channel 6. For cable channels
100 through 125, press and hold the
3
3
1 key until C1–– appears. Then press
the other two numbers.
6
6
Caption Key (See page 10.)
9
9
V-Guide Key (See pages 11 ~13.)
SLEEP
12
Reset Key
Press this key twice to restore factory
settings. The TV will automatically
start Channel Search and clear all
customized settings. (See page 13.)
Power Key
Press to turn TV on or off.
Recall Key
Select a channel then select another
channel using the number keys. Press
Recall to switch between the
channels.
11
Display Key
Press once to display the channel
number. Press twice to display the
channel number continuously. Press
again to remove the display.
12 Sleep Key
/ and
Use this key with the "0" key to set
the Sleep Timer (see page 14).
/ )
/ ) Keys