Publicidad
Idiomas disponibles
Idiomas disponibles
Adjusting the cleaning head
You can adjust the angle of the cleaning
head to suit your requirements. The device
has the following setting options:
For users up to 177 cm tall.
For users taller than 178 cm.
For use under objects (e.g.
benches).
1. Press the cleaning head unlocking but-
ton.
2. Adjust the cleaning head.
Illustration L
Inserting the battery pack
ATTENTION
Dirty contacts
Damage to the device and battery
Check the battery mount and the contacts
for soiling and clean them as necessary be-
fore inserting the battery.
Illustration M
1. Push the battery into the mounting in the
device until it audibly latches into place.
Removing the battery
WARNING
Uncontrolled startup
Risk of injury
Remove the battery pack from the device
during work breaks and before carrying out
any service or care work.
Illustration N
1. Press the unlocking button.
2. Remove the battery from the device.
Operation
Switching on the device
You must press the unlocking button to enable
the trigger (safety function). Only then can the
device be switched on via the trigger.
1. Press the trigger lockout button.
Illustration O
2. Press the trigger at the same time.
The device starts up.
3. Release the trigger lockout button.
The device continues running.
4. Release the trigger.
The device stops.
Removing weeds
Note
Please note that the device only removes
weeds at the surface. It does not remove
the roots.
Note
We recommend using the device only in a
horizontal, slightly angled position. Vertical
use can result in faster wear of the bristle
strip.
The gentle nylon brush is capable of re-
moving a wide range of weed types from
and between almost any hard surface. The
cleaning results can however vary depend-
ing on external influences (ambient humid-
ity, ground moisture and ambient
temperature).
ATTENTION
Risk of damage
Do not scrub with the device or use the pro-
tective cover for scraping. This may dam-
age the device
1. Always guide the device with slow
movements over the surface to be
cleaned, at a slight angle without apply-
ing any pressure. Do nor guide the de-
vice flat over the surface.
Illustration P
2. Work on stubborn weeds multiple times
slowly.
3. Hold the device at the side of the second
handle when cleaning joints so that it is
slightly titled. Please note that loose ma-
terial in the joint may also be removed.
CAUTION
Failure to observe the weight
Risk of injury and damage
Be aware of the weight of the device during
transportation.
CAUTION
Failure to observe the weight
Risk of injury and damage
Be aware of the weight of the device during
storage.
English
Transport
Storage
15
Publicidad
Capítulos
