Comunello Automation QUAD - 230V - 2M Instrucciones De Uso Y De Instalacion página 28

5 DESCRIPTION AND PROGRAMMABLE FUNCTIONS
The control panel has a MAIN MENU and two sub-menus called EXTENDED MENUS to customize the programming and the various system functions.
Pressing the SELECT button several times in succession you can scroll through the menu displayed by the 7 LEDs to choose the desired function
(flashing LED correspondingly flashing) and change its functionality with the SET button (the LED becomes fixed with function enabled or, conversely,
off with function disabled).
The first available menu is the MAIN menu summarized in Tab no. 2:
•
MAIN MENU
Press the SELECT button and select the desired function
from the main menu.
LIVEL 0 - MAIN MENU
LED FUNCTION DESCRIPTION
L1 DELAY Door selection at start
L2 STEP BY STEP Selection of opening logic
L3 TX CODE Programmes remote controls
L4 CONDO Enables the "Condominium"
function
L5 MOTOR TIME Configures the movement and
deceleration time
L6 PAUSE TIME Automatic closure setting
L7 PED TIME Pedestrian stroke time
Table 2
The Second menu is the one defined as EXTENDED 1 and to access the programmable functions follow the instructions given in Tab. 3:
EXTENDED • Press the SELECT button and scroll the LED menu until
MENU 1 you reach the LEV LED;
• Press SET once to access the EXTENDED MENU 1.
LIVEL 1 - EXTENDED MENU 1
LED FUNCTION DESCRIPTION
L1 PGM CODE Remote control programming
L2 PHOTOCELL TEST Carry out the Photocell test
before each movement
L3 STEP-BY-STEP 1 STEP-BY-STEP (P/P) Control
PROCEDURE logic
L4 DOOR DELAY Adjustment of the delay betwe-
en the two doors
L5 WATER HAMME- Enabling of the opening push to
RING unlock the solenoid interlock
L6 HAMMERING Activation of thrust in closing to
CLOSING unlock the solenoid interlock
L7 PRE-FLASHING/ Pre-flashing or courtesy light
COURTESY LIGHT function
Table 3
28 COMUNELLO ®Copyright 2019 - All rights reserved
The LEV function LED stays on FIXED:
LED ON
Opens to left
Open-stop-close-stop (closes in pause in partial opening)
TX PP TX P.PED
After the first, the other Commands are ignored during opening
and the pause time
Programmed work time
Manually programmed automatic closure
Programmed MOT 1 work time
The LED of the LEV function FLASHES with this frequency
LED ON
Enabled function
Enabled function
Open-stop-close-stop (IT DOES NOT CLOSE in pause in partial
opening)
4 s. fixed in OPEN, adjustable from 4 to a max. 15 s. in CLOSE
Water hammering function enabled
Closing function at full power for 1 sec.
3 sec. of pre-flashing before Flashing active for 3 min. after
closure opening command
LED OFF DEFAULT
Motor no.2 delay
Automatic (open-close)
No remote control
Disabled function
30 seconds, without decelera-
tion (default)
Disabled function
10 seconds, without decelera-
tion (default)
LED OFF DEFAULT
Disabled function
Disabled function
Open-stop-close-stop (closes
in pause in partial opening)
No delay
Disabled function
Disabled function
Disabled function