Battery Replacement - TFA 35.1139 Instrucciones De Uso

TFA_No. 35.1139_Anleitung_09_20
METEO SENS - Wireless weather station
• The maximum values measured since the last reset appear on the display.
• Press the MAXMIN/+ button again.
• appears on the display.
• The minimum values measured since the last reset appear on the display.
• When the maximum or the minimum values are displayed, press and hold the MAXMIN/+ button for
three seconds to reset the corresponding values.
• Press the MAXMIN/+ button again to return to normal mode.
7.6 Additional outdoor transmitters
• When having more than one external transmitter, select a different channel for each one by the CH
1/2/3 switch inside the transmitter's battery compartment. Insert two new AA 1,5 V batteries, polari-
ty as illustrated. Start the base station operation or the manual search for the outdoor transmitter:
• Choose the respective transmitter by pressing the CHANNEL button.
• Press and hold the CHANNEL button on the base station for three seconds. The registered transmit-
ter (channel) will be canceled.
• Press the TX button in the corresponding transmitter's battery compartment. The transmission of
the outdoor data will take place immediately.
• The outdoor values and the channel number will be shown on the base station display. If you have
installed more than one outdoor transmitter, press the CHANNEL button on the base station to
change between the channels 1 to 3.
• You can also choose an alternating channel display. Press the CHANNEL button. After the last regis-
tered channel (1 to 3) a circle symbol will appear. To deactivate the function press the CHANNEL but-
ton again.
• After successful installation close the outdoor transmitter's battery compartment carefully.
30
10.09.2020 19:51 Uhr Seite 16
METEO SENS - Wireless weather station
8. Positioning and mounting of the base station and the transmitter
• When placed outdoors, choose a shady and dry place for the transmitter. Direct sunlight may trigger
incorrect measurement and continuous humidity damages the electronic components needlessly.
• Place the base station in any room of the house. Avoid the vicinity of any source of interference such
as computer screens, TV sets or solid metal objects.
• Once the desired location is chosen, check whether the transmission from the transmitter to the
base station is possible (transmission range of up to 80m in open areas). Within solid walls, espe-
cially ones with metal parts, the transmission range can be reduced considerably.
• If necessary choose another position for the transmitter and/or base station.
• Once the transmission is successful, you can wall mount the transmitter or place it onto a flat sur-
face.
9. Care and maintenance
• Clean the device with a soft damp cloth. Do not use solvents or scouring agents.
• Remove the batteries from all instruments if you do not use the products for a long period of time.
• Keep the devices in a dry place.

9.1 Battery replacement

• When the battery symbol appears on a channel display, change the batteries of the respective trans-
mitter.
• Change the batteries of the base station, when the battery symbol appears on the display of the
indoor values.
• Please note: When the batteries are changed, the contact between the transmitters and the base
station must be restored – so always insert new batteries into all devices or start a manual transmit-
ter search.
31