One Shot Leading Edge; One Shot Trailing Edge; Timer Scale; Timer Value - CARLO GAVAZZI LD30BI10BPIO Serie Manual De Instrucciones

2.4.4.1.5. One shot leading edge

Each time a target is detected in front of the sensor the switching output generates a pulse of constant
length on the leading edge of the detection. This function is not retriggerable. See figure below.
Presence of target
N.O.

2.4.4.1.6. One shot trailing edge

Similar in function to the one shot leading edge mode, but in this mode the switching output is changed on
the trailing edge of the activation as shown in the figure below. This function is not retriggerable.
Presence of target
N.O.

2.4.4.2. Timer scale

The parameter defines if the delay specified in the Timer delay should be in milliseconds, seconds or minutes

2.4.4.3. Timer Value

The parameter defines the actual duration of the delay. The delay can be set to any integer value between
1 and 32 767.
16
Rev.00 - 01.2020 | LD30 IO-Link manual ENG | © 2020 | CARLO GAVAZZI Industri
∆t ∆t
∆t ∆t
∆t ∆t
Example with normally open output
∆t ∆t
Example with normally open output