Oster CKSTPCEC8801 Manual De Instrucciones página 44

If food sticks or burns to the surface of the Cooking Pot, then fill it with hot soapy water
and let it soak before cleaning. Use a rubber or nylon spatula to remove stubborn
residue. If scouring is necessary, use a non-abrasive cleaner and a nylon scouring pad or
brush.
Although the Cooking Pot is dishwasher safe, we recommend hand-washing to preserve
the non-stick coating.
If white spots form on surface of Cooking Pot, then soak it in a solution of vinegar or
lemon juice and warm water for 30 minutes. Rinse and dry.
Note: Never use metal utensils or cleaning devices on the Cooking Pot, as this may
result in scratching and damaging the non-stick coating.
Exterior
Wipe the exterior of the Heating Base with a damp cloth and polish dry. DO NOT use
harsh abrasives, scourers or chemicals, as these will damage the surfaces. To prevent
damage to the Multi-Cooker do not use alkaline cleaning agents when cleaning. Only use
a soft cloth and mild detergent. Never immerse the heating base in water or any other
liquid.
Condensation Collector
Empty any collected water from the Condensation Collector after each use. Wash in
warm, soapy water.
Lid and Sealing Gasket
Always examine the gasket before each use. The silicon Sealing Gasket on the inside of
your Multi-Cooker Lid may deteriorate over time. Remove Sealing Gasket for cleaning
as needed. Hand clean using warm, soapy water, dry thoroughly, and replace Sealing
Gasket in Lid before use. Leave the Lid upturned for storage, as this will also extend the
life of the gasket. Sealing Gasket may need to be replaced every 1 – 2 years depending
on regular use. Contact Oster customer service or visit www.oster.com to order
®
replacement parts.
Valve REMOVE
Steam Release Valve
Ensure the Steam Release Valve is clear from debris before you
begin using the Multi-Cooker. Remove the valve and gently clean.
Ensure it is completely dry before replacing.
Steam Release Valve Cover
The Steam Release Valve Cover is on the underside of the Lid.
Ensure it is clear from debris before you begin using the Multi-
Cooker. To clean, carefully pull the cover off and clean using
warm, soapy water. Press the cover back into its place after
cleaning is complete.
UNDERSIDE OF LID
Figure 7
Bobber Valve
Steam Release Valve Cover
Figure 8
Bobber Valve
Gently press the valve up and down 2-3 times and ensure it is clear from debris before
you begin using the Multi-Cooker.
E 18
CKSTPCEC8801_18SEM2 (LA).indd 18 12/13/18 09:11