Zanussi ZRB629W Manual De Instrucciones página 18

Problem
The appliance is noisy.
The compressor operates contin-
ually.
Water flows on the rear plate of
the refrigerator.
Water flows into the refrigerator.
Water flows on the ground.
There is too much frost and ice.
The temperature in the appliance
is too low.
The temperature in the appliance
is too high.
The temperature in the refrigera-
tion is too high.
The temperature in the freezer is
too high.
The appliance does not operate.
18
Possible cause
The appliance is not supported prop-
erly.
The Temperature regulator may be set
incorrectly.
The door is not closed correctly.
The door has been opened too fre-
quently.
The product temperature is too high.
The room temperature is too high.
During the automatic defrosting proc-
ess, frost defrosts on the rear plate.
The water outlet is clogged.
Products prevent that water flows into
the water collector.
The melting water outlet does not flow
in the evaporative tray above the com-
pressor.
Products are not wrapped properly.
The door is not closed correctly.
The Temperature regulator may be set
incorrectly.
The Temperature regulator may be set
incorrectly.
The Temperature regulator may be set
incorrectly.
The door is not closed correctly.
The product temperature is too high.
Many products are stored at the same
time.
There is no cold air circulation in the
appliance.
Products are too near to each other.
The appliance is switched off.
The mains plug is not connected to the
mains socket correctly.
Solution
Check if the appliance stands stable (all
the four feet should be on the floor).
Set a warmer temperature.
Refer to "Closing the door".
Do not keep the door open longer than
necessary.
Let the product temperature decrease to
room temperature before storage.
Decrease the room temperature.
This is correct.
Clean the water outlet.
Make sure that products do not touch
the rear plate.
Attach the melting water outlet to the
evaporative tray.
Wrap the products better.
Refer to "Closing the door".
Set a higher temperature.
Set a higher temperature.
Set a lower temperature.
Refer to "Closing the door".
Let the product temperature decrease to
room temperature before storage.
Store less products at the same time.
Make sure that there is cold air circula-
tion in the appliance.
Store products so that there is cold air
circulation.
Switch on the appliance.
Connect the mains plug to the mains
socket correctly.