Cleaning And Maintenance; Maintenance; Periodical Cleaning To Be Carried Out By The User - Dal Zotto TECLA Manual Del Usuario

CLEANING AND MAINTENANCE

ALWAYS FOLLOW THE INSTRUCTIONS IN MAXIMUM SAFETY CONDITIONS!
Š Make sure the power cable's plug has been pulled out, as the generator might have been programmed to turn on.
Š Make sure all the parts of the generator are cold.
Š The ashes are completely cold.
Š Ensure enough ventilation in the room when cleaning the product.
Š Poor cleaning a ects correct operation and safety!

MAINTENANCE

To ensure correct operation, the generator must undergo routine maintenance carried out by a quali ed technician, at least once a year.
Periodic inspection and maintenance operations must always be carried out by specialised technicians, who are authorised and work in
accordance with current regulations and the instructions reported in this user and maintenance manual.
EVERY YEAR, HAVE THE FLUE EXHAUST SYSTEM, SMOKE DUCTS AND T SHAPED FITTINGS SUPPLIED AND
INSPECTION PLUGS CLEANED IF THERE ARE ANY BENDS AND ANY HORIZONTAL SECTIONS!
THE CLEANING SCHEDULE FOR THE GENERATOR IS ONLY MEANT AS A GUIDE! IT DEPENDS ON THE QUALITY OF THE
PELLETS USED AND HOW OFTEN THE EQUIPMENT IS USED.
THESE STEPS MAY NEED TO BE PERFORMED MORE OFTEN.

PERIODICAL CLEANING TO BE CARRIED OUT BY THE USER

As speci ed in this user and maintenance manual, periodic cleaning operations must be performed with the utmost care after reading the
instructions, procedures and times reported in this user and maintenance manual.
CLEANING THE SURFACES AND COVERING
Never use abrasive or chemically aggressive detergents to clean!
Surfaces must be cleaned when the generator and covering are completely cold. To carry out maintenance on surfaces and metal parts, just
use a cloth dampened with water or water and neutral soap.
Failure to comply with the directions can damage the generator's surfaces and void the warranty.
CLEANING THE CERAMIC GLASS
Never use abrasive or chemically aggressive detergents to clean!
The ceramic glass must be cleaned only when the glass is completely cold.
To clean the ceramic glass, use a dry brush and a newspaper that has been dampened and passed through some ash. If the glass is very dirty,
only use a detergent speci cally designed for ceramic glass. Spray a modest amount on a cloth and use it on the ceramic glass. Do not spray
the detergent or any other liquid directly onto the glass or gaskets!
Failure to comply with the directions can damage the surfaces of the ceramic glass and void the warranty.
CLEANING THE PELLET TANK
When the tank is completely empty, unplug the generator's power supply cable and rst remove residues (dust, shavings, etc.) from the empty
tank before emptying it.
DAILY
BURN POT CLEANING
Š Vacuum the residues in the burn pot
Š Take out the burn pot from the designated compartment;
Š Vacuum the ash from the burn pot seat, the combustion
chamber and ignition plug tube .
Š Use the special poker supplied to clear the holes in the burn
pot.
Š Place back the burn pot and push it towards the hearth wall.
Š If the ash collector tray contains ash, vacuum the deposits.
PLEASE NOTE: USE A SUITABLE VACUUM CLEANER WITH A
SPECIAL CONTAINER TO SEPARATE THE COLLECTED ASH.
52 ENGLISH
ignition plug tube