CEMB SM628 Manual De Uso página 23

6.3.2 Selector functions (fig. 21)
The Selector has four positions:
- position 1: memorises and corresponds to the external diameter (small diameter) in
the demounting phase;
- position 2: memorises and corresponds to the internal diameter (large diameter) in the
demounting phase;
- position 3: memorises and corresponds to the bead mounting phase by external and
internal diameter;
- position 4: memorises and corresponds to the Clippé Support extraction phase.
6.3.3 Bead breaking of the lower bead
(Common procedure for Pax System with full width or clippé rest)
IMPORTANT
Before demounting the tyre, the selector must be calibrated in order to memorise the
tool position when demounting tyres of the same size.
6.3.4 Selector calibration
Note:
When working on a set of wheels of the same size, the tool positions can be memorised
by means of the Selector.
- Using the pneumatic lever switch (G), lower the arm of the cylindrical roller (B) fig.22.
- Place the cylindrical roller on the edge of the rim fig.22.
- Place the selector (E) on position 1 and secure it using the handle (F) fig.23.
User's manual
Pos. 1
Pos. 2
Pos. 3
Pos. 4
21
23
EN